
EN - 77
elproVIEWER
SI3001Ea
CONFIGURATION OF AN ELPROVIEWER REPORT
6
6.2.2.2 Threshold values
These parameters are used to modify the critical threshold values for the assessment
report.
• Entry of threshold values
In assessment reports with several PDF reports the threshold values of the first PDF
report are used or new values are defined.
Only if "manual " is selected, the threshold values can be redefined.
• Temperature / Relative humidity
"Activate" must be selected to select the alarm modes.
• Alarm mode
Different alarm modes are available
•MKT
An alarm can be calculated and assessed for the MKT with specified parameters.
Assessment must be activated.
2.1.5 Calculation
• Duration
The total alarm duration is treated as a threshold value.
"Activate" must be selected for assessment.
Threshold values Information on the definition of the threshold values in the LIBERO PDF report
8.1 Alarm & threshold values
6.3 Chart - highlight
Standard representation: All lines are set to "highlight"
With the "All left Y axes" function and "All right Y axes" the lines that are not assigned to the
axis are shown in a (lighter) pastel color. The function does not weaken the observed lines.
In the following example only curves 1 and 4 are highlighted. The representation of a curve
is changed by clicking the respective light bulb.
NO FUNCTION, IF ONLY ONE CURVE IS SHOWN.
Comentários a estes Manuais