ELPRO 805U-E Manual do Utilizador descarregar pdf (Página 71)

Appendix A Firmware Upgrade

Page 71 © April 2007

7. Firmware upgrade will proceed, and should take about 1 minute if performed locally.

If performed over a radio link, the upgrade may take between 4 to 20 minutes,

depending upon the quality of the radio link, and the amount of traffic on the network.

During the upgrade, the webpage shows a progress bar at the bottom right side of the

browser window.

When upgrade is completed, the System Tools webpage will be shown if “Save to

Flash” was clicked. If “Save to Flash and Reset” was clicked, the unit will display a

message that the module is resetting.

Firmware upgrade is now complete.

Manual Upgrade using Flash Update

1. Connect the module’s ethernet port to PC ethernet port via a “straight through”

ethernet cable. “Straight through” ethernet cable is typically a blue colour.

Alternatively, connect the module to PC via a network switch or hub, as some

configurations of Windows can encounter difficulty upgrading without a hub

connected. On some PCs, Windows can take much longer than expected to initialise

its network interface when the device is reset - connecting via a hub/switch removes

this issue during the upgrade procedure.

2. Switch dip-switch on module to SETUP mode.

3. Power up the module and wait a couple seconds. This will ensure that Windows

networking can correctly detect an operating ethernet port.

4. Ensure your PC network settings have a Subnet Mask of 255.255.255.0. This can be

easily checked using DOS command IPCONFIG.

5. Extract FlashUpdate program, and start the program.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 79 80

Sem comentários

ELPRO 805U-E Manual do Utilizador Página 71