ELPRO 805U-E Manual do Utilizador descarregar pdf (Página 24)

805U-E Wireless Ethernet User Manual

Man_805U-E Rev 1.5 Page 24

3.3.2 Set 805U-E to same network as PC

This is the alternate procedure to setting an IP address in the 805U-E. Consult your network

administrator for an IP address on your network, the gateway IP address, and network mask.

a) Switch Factory Default dip-switch on 805U-E to SETUP position.

b) Connect the RS232 port on the 805U-E to the RS232 port on the PC using a “straight-

through” serial cable.

c) Open a terminal package (such as Hyperterminal) with 19200bps data rate, 8 data bit, 1

stop, no parity and no flow control. Make sure that no other programs have control of

the serial port.

d) Power up 805U-E. Basic network settings will be displayed on the terminal as illustrated

below. When prompted, hit enter key to stop automatic boot process. You have 5

seconds to abort the boot process.

My Right Boot 2.1

This software is provided by Cybertec ``as is'' and with NO WARRANTY.

http://www.cybertec.com.au/

ROM : 256KB @ 0xffe00000

RAM : 8192KB @ 0x00000000 (141KB / 0x0002366c)

ROM Configuration table ... PASSED.

RAM address pattern check . PASSED.

RAM address bus check ..... PASSED.

Product : E900P R2.3F

Variant : default-variant

Serial No. : 09040569 - 012345678910

Release : epm_mrb_elpro_E900P_1.5

Released date : 11 August 2005

Released host : Anxosity

Build date : Thu Aug 11 12:01:05 2005

Build host : Anxosity

Boot Flags : no RAM test, no ROM test, bus timer on, wdog on

static IP, auto-boot, net-boot, reset on

local file, no binary load

Boot delay : 0

Boot Filename : /memory/0xffe40000,0x60000

Boot Address : 192.168.123.113

Boot Netmask : 255.255.255.0

Boot Gateway : 192.168.123.113

Boot Host : 192.168.123.1

Boot Mac 0 : 00:12:af:00:00:10

Boot Mac 1 : 00:12:af:00:00:10

RTE data store .... no error

Setting bus timer (on) and watchdog (on) ... PASSED

Recovery Configuration :

ip address : 192.168.0.110

net mask : 255.255.255.0

gateway : 192.168.0.1

host : 192.168.0.1

eip: mount point /memory

fec0: connected at 100M Full Duplex.

fec0: local ip = 192.168.0.110, server ip = 192.168.0.1

Press ENTER to abort automatic booting ... 5

e) Check values for Boot Address, Boot Netmask, and Boot Gateway. These values should

be set to reflect those of the PC you are using to configure the unit. If these are correct

skip to step (h). You may check settings again with the rct command. For further help,

type the help command.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 79 80

Comentários a estes Manuais

Sem comentários

ELPRO 805U-E Manual do Utilizador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Redes ELPRO 805U-E